Mitsubishi Eclipse 3G Club banner
crankshaft postion sensor
1-5 of 5 Results
  1. Problem Reports
    Hello everyone, I have had one of those jobs that quickly became a nightmare and need some advice. The car I am working on is a 2000 Mitsubishi Eclipse GT with stock V6 3.0L engine and manual transmission. As for the problem, I was working on replacing the timing belt, everything was going...
  2. New Members Forum
    hey guys I have a 2003 gt with a manual tranny. My car is throwing 5 codes right now, 3 for the o2 sensors saying too lean/too rich and the other two is one for the crankshaft position sensor and the camshaft position sensor. (PO0335 and PO0340) my question is, why would all these codes be...
  3. 1G/2G Eclipse General Discussion
    Im having a couple of issue with my 98 Eclipse RS. After it running for a minute at a idle it starts to run rough and pulsate(Rpm's slightly up/down sparaticly), also the engine vibrates at the same time. Past day or so its become sluggigh bewteen 2-3k when accelerating. Ive done some research...
  4. Problem Reports
    YEAR: 2001 SUBMODEL: Stock GT Spyder TRANSMISSION: Manual MILES: 172000 PROBLEM: Last Friday I started the car in the evening and started hearing a very loud tick that matches RPMs coming from what sounds like under the intake manifold. Sounds like a diesel engine. About 3-5 times louder than...
  5. Problem Reports
    I have a 2000 Eclipse V6 with 98k. I recently had a problem with the car not starting, I replaced the battery, had the starter checked, everything checked out ok. This problem was on and off for a few days. Sometimes it would start no problem, others it would just click, but not turn over...
1-5 of 5 Results
Top