Mitsubishi Eclipse 3G Club banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. Problem Reports
    So I've been struggling with this problem for a while now and I don't know what else I could possibly check in the EGR system. I know there's been a million threads on EGR problems but I've been looking through most of them and all they say is "just clean EGR" or "Replace EGR" or "check your...
  2. Problem Reports
    2003 Eclipse Spyder GTS. 5 Spd Man 3.0 V6 Im pulling a P0401 Code saying exhaust Gas Recirculation Flow Insufficient Detected. Anyone have any advice on this ?? Just replaced all of the 02 sensors. Thnx in advance
  3. Problem Reports
    The EGR was removed by the previous owner of my 2001 GT, which is fine with me. The hole in the intake manifold was also welded shut, which again is OK -- but as many of you are probably already aware, is trips a code and therefore the SES is always lit. Is there any additional modification that...
  4. 3G Eclipse RS/GS Specific
    Hey everyone, I'm having the wonderful P0401 CEL and I'm trying to clean out my EGR valve but I can't reach it. Is there any special way to unbolt it or reach it? Thanks
  5. Problem Reports
    Hey all, I really appreciate this forum and have managed to get by the past few years after buying my 3G with just digging thoroughly around the site. However, I've hit a bit of a dead end on troubleshooting a problem I have with my car. The lay: 2.4L 2002 Eclipse GS Automatic with about 120k...
  6. 3G Eclipse GT/GTS Specific
    Does anyone have any idea what size the crossover pipe between the EGR valve and exhaust manifold is?
  7. Problem Reports
    What's up... I drive a 2001 Eclipse GT Spyder 3.0 and I've been having EGR related codes which caused misfires and low surging idles. So I searched and found a post on removing the vacuum hose that runs to the EGR and letting it hang there and to wait like 3 days. Well I went and unhooked the...
  8. Problem Reports
    From the beginning. Car sounds and feels fine, but fails emissions, take it to the mechanic, he does stuff and gives it back. Immediately I notice a Rough Idle and take it back, he says it's normal. I accept and continue. Next day I get a P0400 trouble code, call mechanic, he says "Disconnect...
1-8 of 8 Results