Mitsubishi Eclipse 3G Club banner

injectors

  1. Problem Reports
    backstory: 2002 rs 200k a/t injector 3 and 4 arent pulsing, injectors are clean, im thinking injector harness, maybe bad ground or ecu or something, did light test and some research, i know the ground isnt constant but the light is on constantly for injector 3 and 4 (from left to right) im stuck...
  2. Problem Reports
    2001 Eclipse GT spyder 5-speed. Okay so I've started to get this really bad noise from the back of my car when I start it. This only happens after I start it up after driving for a while and the engine is completly warmed up. For example I would go to the store, and after shopping I would come...
  3. Performance
    note: Voodoo supplied me with the information on how to do this on my build. I'm simpy relaying it onto here for the convenience of the community. The walk-through is based on my personal experience. You will need: -Low-impedence injectors -Injector clips -Resistor pack -Wire cutters/strippers...
  4. Cars for Sale/Wanted
    2001 Mitsubishi GS Turbo Mileage: 176,000 miles Engine and Mods: Stock 2.4l 4g64 Refreshed head at 165,000 miles - Valve job, resurface, valve stem seals, mild smoothing of runners Balance Shaft Eliminator Kit Genuine Mitsubishi 16g turbo Custom 2.5 inch o2 housing Custom 2.5 inch down pipe...
  5. Automotive For Sale / Wanted
    FS!: HKS 272 cams,Delphi 1000cc Injectors,2 Evo 8 turbos/housings, Sard Boost Trigger Here are some parts that I have for sell. Im open to any offers.I would be willing to trade the cams for newer GSC S2's or shoot me an offer if you have some other cams that you are willing trade just let me...
  6. GT/GTS
    Can/would someone please lead me to a good chart of vehicle models with injector sizes? I found one that said 89-98 DSMs (talon/eclipse) had 450cc injectors, but is that all talons/eclipses from 89-98, or certain models. I am planning to hit up Pull-a-Part soon and don't want to grab the...
  7. GT/GTS
    hey everyone, ive been putting it off for a while but i am going to soon be installing my sds. i have one bump in the road as of now though, i have been calling around trying to find someone to tune it after it is installed but have had no luck really as of yet. i was curious if anyone had a...
  8. Automotive For Sale / Wanted
    FS: 2.4 Intake, Rear GT Calipers, Drive Shaft and More I have several parts that I am trying to clear out, I want it all gone. All 3G eclipse parts have about 23k miles and in great shape. 2.4L Intake Manifold $125 Shipped Door Handles $10 Shipped each Cruise Control Pump $25 Shipped Door...
  9. GT/GTS
    I'm running 440's on my 3.0 with an e-manage for tuning. I took it to a tuning shop and they readjusted my tune quite a few times just to find that the car wants to stall when it is cold and after its under heavy load and I stop at a light. The blow off valve was just cleaned and my vaccuum is...
  10. GT/GTS
    I've looked around for tips on any injector install and havent seen anything. I just picked up 2 sets of srt4 injectors and got them in. Go to crank it over and it wont start and I smell gas and find it leaking everywhere. I have 2 o-rings on the tops of the injectors and the one large one on...
  11. GT/GTS
    I thought I'd post the flow test results of the 310cc injectors that I'll be using for my SDS stage I install. I'll try to explain the columns: -First column is injector, assigned by number (they are not in order here). -Second is Wide Open for one minute (they ranged from 307cc-320cc, all...
  12. GT/GTS
    Ok guys Im almost finished with my turbo set up and im narrowing down my fuel set. I was looking into some venom injectors. Flow rate 30lbs/hr. Is this a good size. I will be starting out at 6psi for a start but i will be increasing boost when i finish my spare bottom end. I will be also adding...
  13. GT/GTS
    I have a question and before you all scream SEARCH, I want you to know that I have already done some mild searching and couldn't come up with what I was exactly looking for. Now, I have been toying with the idea of a turbocharger recently for my 02 GT. However, before I make my little personal...
  14. GT/GTS
    I already have a Walbro 255 fuel pump installed. That has been working fine. I just installed some 440cc injectors from Tearstone. They fit fine and I see no leaks, but I cannot get my engine to start. I do NOT have an FPR and as far as I can tell, this is related to fuel pressure. If I...
  15. GT/GTS
    I just finished installing the emanage ultimate. I double checked all of the connections with a multimeter and they are fine. Keep in mind, I have no FI yet. When I start the car, everything is normal; idles perfecly, drives and accelerates just as before. However, I keep on getting P0201...
  16. GT/GTS
    What are everyone's opinions on what fuel injectors to run with a stage 1 SDS? I plan on having my system installed in the spring (I bought a used kit) and I was wondering if it would be better to run 310 cc injectors or the stock injectors plus the supplemental ones, similar to Ripp's new...
  17. GT/GTS
    I have been running 440cc injectors on my car for a while with SDS, I cannot get my car to idle good. I am currently adding 13% on the airflow map of the emanage, adding 8% on the injector map and have the injector correction 210/440 on the parameters. I have been messing with all these numbers...
  18. GT/GTS
    well after hours and hours of reasearch and talking with all of my dads friends who run pro stocks and outlaws, i have come to the conclusion that marren fuel injection is the only way to go now for FI. NOt only do the have a good rep,but there products can not even be matched be any company by...
  19. GT/GTS
    what injectors are you guys running and where did you buy them from. Also lookin for a good place to buy rc injectors from any help?
  20. GT/GTS
    Ok I have got a hook up ahhah won't list the price but I will be getting my Turbo Kit very soon,Sorry Tear but its dirt cheap have to add a little but hell it will come less then anyones kit.I will get a custome made Mannifold and a T4 turbo all hoses and lines FMIC, pipeing,BOV & Wastegate. I...
Top