Mitsubishi Eclipse 3G Club banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 · (Edited)
Hey all, yesterday i replaced the bank 2 sensor 2 o2 and when i was done the car fired right up. i drove it off the ramps, parked it, and cleaned up shop before i went to pull it back in. This time when i started it, it promptly died. Im at a loss guys all i did was replace an o2. nothing else was touched and it was running fine before the fix. i did unplug the the black connector above the b2 s2 connector just to make life easier but everything is hooked back up properly. any input?


*****UPDATE*****
today i borrowed a obd reader and im not throwing any codes......
 
1 - 1 of 1 Posts
Top