Update and finally a dyno

1381 Views 25 Replies 14 Participants Last post by ICEMAN99TURBO, Jun 10, 2008

Chippy

Discussion Starter · Jun 6, 2008 (Edited)

So everyone that went to Alum should know about the little mishap I had with my car immediately after the meet. Mad props to Ian who took a drinking break from D n Bs and picked Krissie and I up stranded at the Lowes next door. The car has been in and out of the shop over the last few weeks, but they figured out what was wrong and basically fixed everything - new fuel assembly cause something happened to the pump and filter, new igniter to the MSD because of failed soldering, repaired air/water cooler tank due to bad welding (temps much improved now), new battery, alignment, and a whole lot of tuning. Don't know what psi they got and it was pretty warm, but I was pretty happy with the results below. Get to pick it up tomorrow and finally start enjoying her for the summer! Numbers are whp, not engine.

Crow - you do not get to make comments on SDS and shop time... :fawk:

See less See more

1 - 20 of 26 Posts

Special_K

· #2 · Jun 6, 2008

Looks good, now get out and drive it :wub:

We will have to rock out to Guitar Hero again.

Chippy

Discussion Starter · #3 · Jun 6, 2008

CLIPSE_GT said:
We will have to rock out to Guitar Hero again.

:hbang: :hbang:

Crow

· #4 · Jun 6, 2008

Nice numbers. Have to check it out once you get it back.

BEISSEN

· #5 · Jun 7, 2008

NIce number and what is your setup im lost.

Chippy

Discussion Starter · #6 · Jun 7, 2008

BEISSEN said:
NIce number and what is your setup im lost.

Running RIPP SDS. I attached an old linky that has most of my build listed.

http://www.club3g.com/forum/showthread.php?t=88991

Eclipse03GS

· #7 · Jun 7, 2008

Nice work! :bigthumb:

01PATREDGT

· #8 · Jun 7, 2008

Niiiiiiiice:twothumb:

GTEclipse17

· #9 · Jun 7, 2008

Vary nice. :hspin:

Chato

· #10 · Jun 7, 2008

Very nice numbers. Now take it to the track and post some vids.

icemanrld19

· #11 · Jun 7, 2008

post some pic of the setup and mods

michaell32

· #12 · Jun 7, 2008

Nice now get some track times before something else goes wrong.

ICEMAN99TURBO

· #13 · Jun 8, 2008

Wow, beautiful bud! I want a ride. :wub:

Duhh001

· #14 · Jun 9, 2008

I hope you have luck than I had. I want a ride, so I know what mine was supposed to feel like. :twothumb:

Chippy

Discussion Starter · #15 · Jun 9, 2008

Duhh001 said:
I hope you have luck than I had. I want a ride, so I know what mine was supposed to feel like. :twothumb:

So far so good. Found a really good shop here in Cbus that is taking care of me. Bascially we've been "fixing" everything that Detroit half-assed the first time around. Major ouch on my wallet, but, shop has been really impressed with it's performance. Let's hope it stays performing.

Clipse2nr

· #16 · Jun 9, 2008

Very Very Nice!!! Good Work bro!

steadly2004

· #17 · Jun 9, 2008

Very, very nice. When can we see some track slips?? lol

Chippy

Discussion Starter · #18 · Jun 9, 2008

steadly2004 said:
Very, very nice. When can we see some track slips?? lol

Would love to go the track but it's kinda hard when I work 80 hrs a week. :mecry2: Gonna try to go sometime this summer though

steadly2004

· #19 · Jun 9, 2008

Chippy said:
Would love to go the track but it's kinda hard when I work 80 hrs a week. :mecry2: Gonna try to go sometime this summer though

80 hours a week???... holy crap

ICEMAN99TURBO

· #20 · Jun 10, 2008

... That is what happens when you are a Surgeon. :wub:

1 - 20 of 26 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.