Mitsubishi Eclipse 3G Club banner

WTB: 10 Spoke 17" GT rim(s)

315 Views 15 Replies 8 Participants Last post by  Kai
Looking to replace a bent rim.

I have an 02 GT and it has the 10 spoke rims.

Apparently there are TWO styles of the 17" 10 Spoke. Ones that look like the spokes are attached to the rims (these are the ones I am looking for), and the other style is that it looks like the spokes are pressed into the rims and that they are 2 piece...

Mine look like the picture below.



If you got a good one (or more), let me know how much. I am located in Columbia, SC (29223).

Thanks
Jeff
See less See more
1 - 16 of 16 Posts
The other style are from a 03+ GTS and they are a one piece wheel as well an have a silver shine to them and look better imo.
I think hes talking about the gsx wheel they look like those but the only difference is they are a 2 piece wheel.
I think hes talking about the gsx wheel they look like those but the only difference is they are a 2 piece wheel.
right... the other one is a two piece wheel...

Jeff
i have 2 im in portsmouth va 23707 let me know whats up throw me a offer
i have 2 im in portsmouth va 23707 let me know whats up throw me a offer
Cool..You have PM...

Jeff
How much are they worth, cause I am thinking about replacing mine. Then I'd be selling the stock ones.
I've seen sets of 4 going for 150 bucks on here.

Jeff
Yup those are the rims... Those look sold though..
those were sold to me, and just for clarification they are 1 piece
those were sold to me, and just for clarification they are 1 piece
You know have a PM :)
Looks like I am batting 0 here...

Anyone with any to sell?

Thanks.
Jeff
Quick bump to the top. No ones got any to part with?
How much are they worth, cause I am thinking about replacing mine. Then I'd be selling the stock ones.
Let me know you probably couldnt tell but my rear passenger side rim is bent might as well get a back up set of rims :)
1 - 16 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top