Mitsubishi Eclipse 3G Club banner
1 - 20 of 55 Posts

tyger03

· Registered
Joined
·
53 Posts
Discussion starter · #1 · (Edited)
FS: EVO Turbo Set-Up (Drastically Reduced Pricing!!!)

At the end of this summer I had hoped for this turbo set-up that I have been collecting for a year would be in my car. But I have an auto and I can't really find anyone that is willing to tune my car the way I want it and I sure know I can't do it. I am also running of of time and money. I've decided to go N/A and get a header after/if I sell this.

EVO VIII Turbo SOLD
EVO VIII Manifold SOLD
EVO VIII O2 Housing SOLD
New Wastegate Actuator (set at 12psi) SOLD
New Intercooler Piping (3") $50 (MSRP $80)
New X02 Racing Intercooler (Perfect Size) SOLD
New HKS SSQV Blow Off Valve with flange $100 (MSRP $200 for BOV)
New Walbro 255 SOLD
EVO VIII Fuel Rail SOLD
EVO VIII FPR SOLD
EVO VIII Fuel Injectors (560 cc) SOLD
AEM Pulleys SOLD


All that still needs to be done for the potential buyer is $100 for cable and evoscan software, a downpipe, and an angled spacer. I have the gauges, but I would like to keep them. (If you plan on blow-through then you need a GM MAF and MAFT). This kit has potential! It should give 12 psi and horsepower of anywhere from 250 to 275 depending on the tune.

Please tell me if you want to buy I NEED THIS SOLD ASAP!


Image


Image


Image


Image


Image


Image


Image


Image


Image


Image


Image
 
Discussion starter · #15 ·
Well, I'm not really sure, but obviously the manifold and fuel stuff is out of question. I've never heard of anyone using it for a GT b/c its so easy for us 4-cyl's to just bolt on and go b/c the engine is so similar to the EVO's. I'm not sure about the actual turbo, but I know you could use the intercooler, piping, BOV, and Walbro 255...
 
Discussion starter · #18 ·
It will fit an RS and a GS. If you meant a bolt-on in the sense of if it will fit, then yes. If you meant easy to install, then it is easier than other turbo set-ups because a lot of it is from the EVO and it's engine is pretty much the same as ours (just a little smaller). But yes the manifold "bolt's on" to our 4cyl engine. The rest (being the piping, intercooler, intake, and BOV) is up to you to fit it the way you want. The fuel shouldn't be too bad either, just replace our fuel rail and injectors with this one hear and cut the fuel line and put the pump in place....
 
1 - 20 of 55 Posts